Directed Mineralization on Polyelectrolyte Multilayer Films
- PDF / 760,870 Bytes
- 7 Pages / 612 x 792 pts (letter) Page_size
- 12 Downloads / 186 Views
0975-DD06-03
Directed Mineralization on Polyelectrolyte Multilayer Films Maria C. Advincula1, Pritesh A. Patel2, Patrick T. Mather2, Daniel Underhill3, Bryan D. Huey3, and A. Jon Goldberg1 1 Oral Rehabilitation, University of Connecticut Health Center, 263 Farmington Ave, MC-1615, Farmington, CT, 06030 2 Macromolecular Science and Engineering, Case Western Reserve University, 312 Kent Hale Smith Building, 2100 Adelbert Road, Cleveland, OH, 44106 3 Institute of Materials Science, University of Connecticut, 97 North Eagleville Road, Storrs, CT, 06269 ABSTRACT Silica formation aided by polypeptides is being actively investigated for a wide range of applications including biomaterials synthesis, ceramics and controlled release systems. We envision that biocatalyzed mineralization could have application as a dental material where in situ formation of mineral layers could provide needed wear-resistance or sealing capability. The approach would be more clinically relevant if a polymer host could be used to carry and specifically position the biocatalyst on a surface and additionally maintain the catalyst activity. Accordingly, we studied the influence of simple catalytic polypeptides on silica formation from prehydrolyzed alkoxide precursor solutions onto a surface. The polypeptides were localized on to the surface as multilayered thin films using the layer-by-layer (LbL) assembly of polyelectrolytes. Polylysine (PLL) or another biocatalytic polycation, poly(ethyleneimine) (PEI), was adsorbed layer-by-layer up to 10 bilayers on silicon wafers in combination with a negatively charged polyelectrolyte polymer host, poly(sodium-4-styrene sulfonate) (PSS) to prepare PEI-(PLL/PSS)10, PEI-(PEI/PSS)10 and PEI-(PEI/PSS/PLL/PSS)10 multilayer films. Pre-hydrolyzed alkoxysilane solutions were placed dropwise on the catalytic films for silicification. Additionally, the effects of precursor concentration, solvent and drying were evaluated. The morphology, roughness and contact mechanical stiffness of the formed silica were investigated using optical microscopy (OM), scanning electron microscopy (SEM) and atomic force microscopy (AFM). The resulting silica morphology was plate-like or spherical, and porous with average particle size depending on the catalyst and its positions on the surface. Without a catalyst the silica formed over longer times with a fine, gel-like appearance. The morphology of silica produced on the substrate was different from that of particles catalyzed in solution with the same polypeptide catalyst. Additionally, it was found that the homogeneity of PEI-(PLL/PSS)10 films increased with drying temperature, silica precursor concentration, and the presence of ethanol. The contact mechanical stiffness of the silica particles (40 N/m) catalyzed from PEI-(PLL/PSS)10 films was lower than that of the non-silicified areas (48 N/m), suggesting that regions of the silica were amorphous and hydrated. These results show that a polypeptide applied to a surface as a multiple layer with an oppositely charged polymer host (PSS) ma
Data Loading...
