Glossary
In this chapter important terms and abbreviations employed in the book are listed in alphabetical order and explained in detail.
- PDF / 24,820,179 Bytes
- 381 Pages / 439.37 x 666.142 pts Page_size
- 19 Downloads / 138 Views
Springer-Verlag Berlin Heidelberg GmbH
Karl-Heinz John . Michael Tiegelkamp
IEC61131-3: Programming Industrial Automation Systems (oncepts and Programming Languages, Requirements for Programming Systems, Aids to Decision-Making lools
With 139 Figures
Springer
Dipl.-Inform. KARL-HEINZ Irrlrinnig 13 D-91301 Forchheim
JOHN
e-mail: [email protected]
Dipl.-Inform.
MICHAEL TIEGELKAMP
Kurpfalzstr. 34 D-90602 Pyrbaum e-mail: [email protected]
Additional material to this book can be downloaded from http://extras.springer.com.
ISBN 978-3-662-07849-5 ISBN 978-3-662-07847-1 (eBook) DOI 10 .1007/978-3 -662-07847-1
Library of Congress Cataloging-in-Publication Data John, Karl-Heinz, 1995[SPS-Programmierung mit IEC 61131-3. Englishl IEC 61131-3: programming industrial automation systems: concepts and programming languages, requirements for programming systems, aids to decision-making tools / Karl-Heinz John, Michael Tiegelkamp. p. cm. Includes bibliographical references and index. I. Title: Programming industrial automation systems. H. Tiegelkamp, Michael, 1959- III. Title.
T59.5 .J64 2001
670.42'7--dc21
2001018348
This work is subject to copyright. All rights are reserved, whether the whole or part of the material is concerned, specifically the rights of translation, reprinting, reuse of i11ustrations, recitation, broadcasting, reproductioon on icrofilm or in other ways, and storage in data banks. Duplication of this publication or parts thereofis permitted only under the provisions ofthe German Copyright Law of September 9, 1965, in its current version, and permission for use must always be obtained from Springer-Verlag. Violations are Jiable for prosecution act under German Copyright Law. © Springer-Verlag Berlin Heidelberg 2001
Ursprünglich erschienen bei Springer-Verlag Berlin Heidelberg New York 200l. Softcover reprint of the hardcover 1st edition 2001 The use of registered names, trademarks, etc. in this pubJication does not imply, even in the absence of a specific statement, that such names are exempt from the relevant protective laws and regulations and therefore free for general use. Typesetting: Camera ready by authors Cover design: Struve & Partner, Heidelberg Printed on acid-free paper SPIN: 10774431
62/3020/kk - 5 4 3 2 1 0
Preface
The programming of industrial controllers has developed into a fully-fledged engineering discipline in its own right over the last few years. It soon became apparent that the concepts and languages used in office automation were not equal to the task. "Rugged software" and fast adaptability are just two examples of the additional demands made by industrial automation technology. To standardise a variety of modern concepts and languages for the benefit of users, the International Electrotechnical Commission (IEC) developed a standard for using industrial controllers. Based on experience with cxisting PLC languages, five programming languages were defined, together with a data concept using modern software development methods. This book introduces these
