Investigation of High-Efficiency Vibration Energy Transducer with Dual-Modal ZnO Piezoelectric Thin Films
- PDF / 7,007,607 Bytes
- 5 Pages / 612 x 792 pts (letter) Page_size
- 8 Downloads / 218 Views
Investigation of High-Efficiency Vibration Energy Transducer with Dual-Modal ZnO Piezoelectric Thin Films Ying-Chung Chen1, Wei-Tsai Chang1, Chien-Chuan Cheng2, Chun-Kai Mao1 and Kuo-Sheng Kao3,* 1 Department of Electrical Engineering, National Sun Yat-Sen University, No.70 Lienhai Rd., Kaohsiung City, 80424, Taiwan. 2 Department of Electronic Engineering, De Lin Institute of Technology, No.1, Ln. 380, Qingyun Rd., Tucheng Dist, New Taipei City, 23654, Taiwan. 3 Department of Computer and Communication, Shu-Te University, No.59, Hengshan Rd., Yanchao Dist., Kaohsiung City, 82445, Taiwan. E-mail: [email protected] ABSTRACT This paper reports a novel means of integrating a high-performance dual-modal ZnO piezoelectric transducer with a flexible stainless steel substrate (SUS304) to construct dualmodal vibration-power transducers. To fabricate vibration-power transducers, the off-axis RF magnetron sputtering method for the growth of ZnO piezoelectric thin films is adopted. The stainless steel substrate has a higher Young’s modulus than those of the other substrates, and behaves the long-term stability under vibration. The transducer includes a ZnO piezoelectric thin film deposited on the stainless steel substrate combined with Pt/Ti layers at room temperature, which is fabricated by an RF magnetron two-step sputtering system. In this report, the ZnO piezoelectric thin films deposited with the tilting angle of 34° are set by controlling the deposition parameters. Scanning electron microscopy and X-ray diffraction of ZnO piezoelectric thin films reveal a rigid surface structure and a high dual-modal orientation. To investigate the generating characteristics of the dual-modal transducer, two basic experiments of longitudinal and shear modes are carried out. Based on cantilever vibration theory, the cantilever length of 1 cm and a vibration area of 1 cm2 are used to fabricate a transducer with a low resonant-frequency of 65 Hz for the natural vibration. A mass loading at the front-end of the cantilever is critical to increase the amplitude of vibration and the power generated by the piezoelectric transducer. The maximum open circuit voltage of the power transducer is 19.4 V. INTRODUCTION Renewable and green energy systems have received increasing attention in recent years. Alternatives have been actively researched worldwide for considerations such as more compact size, lighter weight, higher density in power, economic value, as well as security and environmental concerns [1-2]. Among the various sources of renewable and green energy systems, the energy of vibration generated simultaneously with the others renewable sources. Furthermore, the vibration energy existed in environment. And two critical transducer technologies that include electromagnetic [3] and piezoelectric transducers have been proposed for use in vibration-energy systems. Many scholars have examined piezoelectric transducers because they require a small working spaces; have a low operating frequency; are environmentally-friendly; exhibit long-term stability.
Data Loading...
