Materials and Manufacturing Processes
This book introduces the materials and traditional processes involved in the manufacturing industry. It discusses the properties and application of different engineering materials as well as the performance of failure tests. The book lists both destr
- PDF / 2,492,097 Bytes
- 113 Pages / 453.544 x 683.151 pts Page_size
- 49 Downloads / 439 Views
Kaushik Kumar Hridayjit Kalita Divya Zindani J. Paulo Davim
Materials and Manufacturing Processes
Materials Forming, Machining and Tribology Series Editor J. Paulo Davim, Department of Mechanical Engineering, University of Aveiro, Aveiro, Portugal
This series fosters information exchange and discussion on all aspects of materials forming, machining and tribology. This series focuses on materials forming and machining processes, namely, metal casting, rolling, forging, extrusion, drawing, sheet metal forming, microforming, hydroforming, thermoforming, incremental forming, joining, powder metallurgy and ceramics processing, shaping processes for plastics/composites, traditional machining (turning, drilling, miling, broaching, etc.), non-traditional machining (EDM, ECM, USM, LAM, etc.), grinding and others abrasive processes, hard part machining, high speed machining, high efficiency machining, micro and nanomachining, among others. The formability and machinability of all materials will be considered, including metals, polymers, ceramics, composites, biomaterials, nanomaterials, special materials, etc. The series covers the full range of tribological aspects such as surface integrity, friction and wear, lubrication and multiscale tribology including biomedical systems and manufacturing processes. It also covers modelling and optimization techniques applied in materials forming, machining and tribology. Contributions to this book series are welcome on all subjects of “green” materials forming, machining and tribology. To submit a proposal or request further information, please contact Dr. Mayra Castro, Publishing Editor Applied Sciences, via [email protected] or Professor J. Paulo Davim, Book Series Editor, via [email protected]
More information about this series at http://www.springer.com/series/11181
Kaushik Kumar Hridayjit Kalita Divya Zindani J. Paulo Davim •
•
•
Materials and Manufacturing Processes
123
Dr. Kaushik Kumar Department of Mechanical Engineering Birla Institute of Technology Ranchi, Jharkhand, India
Dr. Hridayjit Kalita Department of Mechanical Engineering Birla Institute of Technology Ranchi, Jharkhand, India
Divya Zindani Department of Mechanical Engineering National Institute of Technology Silchar Silchar, Assam, India
Prof. J. Paulo Davim Department of Mechanical Engineering University of Aveiro Aveiro, Portugal
ISSN 2195-0911 ISSN 2195-092X (electronic) Materials Forming, Machining and Tribology ISBN 978-3-030-21065-6 ISBN 978-3-030-21066-3 (eBook) https://doi.org/10.1007/978-3-030-21066-3 © Springer Nature Switzerland AG 2019 This work is subject to copyright. All rights are reserved by the Publisher, whether the whole or part of the material is concerned, specifically the rights of translation, reprinting, reuse of illustrations, recitation, broadcasting, reproduction on microfilms or in any other physical way, and transmission or information storage and retrieval, electronic adaptation, computer software, or by similar or dissimilar methodology now known or hereafter develope
Data Loading...