The effect of heat treatment on microstructure and cryogenic fracture properties in 5Ni and 9Ni steel

  • PDF / 3,453,580 Bytes
  • 10 Pages / 594 x 774 pts Page_size
  • 26 Downloads / 258 Views

DOWNLOAD

REPORT

The Effect of Heat Treatment on Microstructure and Cryogenic Fracture Properties in 5Ni and 9Ni Steel J. R. STRIFE AND D. E. PASSOJA Heat treatments were utilized in 5Ni and 9Ni steel which resulted in the development of tempered microstructures which contained either no measurable retained austenite (

Data Loading...

Recommend Documents
Cryogenic fracture toughness of 9Ni steel enhanced through grain refinement

211 17 902KB

Microstructure and Tribological Properties of Tool Steel AISI O2 After Thorough Cryogenic Heat Treatment

215 3 3MB

Effect of Cooling Rate on Microstructure and Mechanical Properties of Eutectoid Steel Under Cyclic Heat Treatment

253 115 4MB

Effect of Heat Treatment on the Microstructure Evolution and Sensitization Behavior of High-Silicon Stainless Steel

204 90 3MB

Effects of Heat Treatment Parameters on the Microstructure and Properties of Bainitic Steel

188 89 3MB

The effect of the austenitizing heat-treatment variables on the fracture toughness of high-speed steel

179 2 2MB

Effects of Cooling Parameter and Cryogenic Treatment on Microstructure and Fracture Toughness of AISI D2 Tool Steel

213 73 3MB

The Effect of Heat Treatment Process Parameters on Mechanical Properties, Precipitation, Fatigue Life, and Fracture Mode

202 94 2MB

Effect of Heat Treatment on the Microstructure and Mechanical Properties of Stainless Steel 316L Coatings Produced by Co

222 101 2MB

Effect of Heat Treatment on Microstructure and Properties of Wear-Resistant Cast Steel with High Strength and Toughness

179 68 47MB

Effect of Heat Treatment Process on Microstructure Evolution and Performance of 45Mn2 Steel

170 81 6MB

A study of the effect of precipitated austenite on the fracture of a ferritic cryogenic steel

166 64 3MB