The value and role of mosquito meshes in low resource and poor income settings
- PDF / 507,183 Bytes
- 2 Pages / 595.276 x 790.866 pts Page_size
- 55 Downloads / 190 Views
LETTER TO THE EDITOR
The value and role of mosquito meshes in low resource and poor income settings B. M. Stephenson1 · A. N. Kingsnorth1 Received: 30 September 2020 / Accepted: 14 October 2020 © Springer-Verlag France SAS, part of Springer Nature 2020
Keywords Low cost mesh · Inguinal hernia repair We believe the report by Wiessner et al.[1] is unsound and the data presented does not amount to an indictment as to the use of low cost mesh in low-income countries. The “massive” shrinkage described by the authors after steam sterilization, has not been our experience. We have used AMSA Plastics low-density polyethylene (LDPE) mesh for inguinal hernia repair, in many low-income countries for more than 5 years in over 10,000 patients with results comparable to commercial meshes. First, the authors did not use any controls for comparison. This is essential to rule out methodological issues during the various pre-sterilization treatments of the meshes. Second, the authors did not describe any measures they took to verify the temperature control of the steam sterilizer. Temperatures inside the device may have exceeded the 121 0C recommended for sterilization of the LDPE mesh. The sterilizer used was apparently of non-medical grade, used commonly for “sterilizing baby bottles”. No self-respecting surgeon would consider implanting a mesh into a patient after “sterilization” by such a ‘Mickey Mouse’ device. Third, the lack of controls means that it is impossible to conclude whether the vigorous pre-sterilization treatment of the meshes with penicillin, streptomycin and amphotericin B had denatured the meshes and rendered them susceptible to the effects of steam and subsequent shrinkage. At this point the reader may be reminded that our own studies found no significant difference when comparing the ultra-structural characteristics and material properties of LDPE mesh to commercial meshes [2]. In rural settings, temperature control of poorly maintained medical-grade steam sterilizers is the most likely cause of
occasional mesh shrinkage, as opposed to a change in mesh characteristics. The many Hernia International volunteer surgeons “working in the field” have occasionally describe such events; but these are rare. Nevertheless when observed, the low cost of a piece of LDPE mesh (
Data Loading...
