Correction to: Analysis of the Influence of the Thickness and the Hole Radius on the Calibration Coefficients in the Hol
- PDF / 206,830 Bytes
- 2 Pages / 595.276 x 790.866 pts Page_size
- 12 Downloads / 166 Views
CORRECTION
Correction to: Analysis of the Influence of the Thickness and the Hole Radius on the Calibration Coefficients in the Hole-Drilling Method for the Determination of Non-uniform Residual Stresses J.M. Alegre 1 & A. Díaz 1
&
I.I. Cuesta 1 & J.M. Manso 2
# Society for Experimental Mechanics 2019
Correction to: Experimental Mechanics (2019) 59:79–94 https://doi.org/10.1007/s11340-018-0433-0 Due to an error introduced during the production process, Fig. 11 appeared incorrectly in the original publication of this article. It appears correctly here.
Publisher’s Note Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
The online version of the original article can be found at https://doi.org/ 10.1007/s11340-018-0433-0 * A. Díaz [email protected] 1
Structural Integrity Group, Escuela Politécnica Superior, Universidad de Burgos, Av Cantabria s/n, 09006 Burgos, Spain
2
SUCONS Research Group, Escuela Politécnica Superior, Universidad de Burgos, C/Villadiego s/n, 09001 Burgos, Spain
Exp Mech
3.00 Simulated coefficients aR0/a1.00 mm z = 0.05 mm
2.00 R0 < 0.94 mm
0
aR / a1.00 mm
ASTM E837-13a correction
1.00
z = 1.00 mm
R0 > 1.06 mm
0.00 0.2
0.4
0.6
0.8
1.0
Radius (mm)
1.2
1.4
1.6
Data Loading...
