Erratum to: Local and Global Mechanical Behavior and Microstructure of Ti6Al4V Parts Built Using Electron Beam Melting T
- PDF / 321,405 Bytes
- 1 Pages / 593.972 x 792 pts Page_size
- 100 Downloads / 193 Views
DOI: 10.1007/s11661-016-3402-1 The Minerals, Metals & Materials Society and ASM International 2016
Erratum to: METALLURGICAL AND MATERIALS TRANSACTIONS A, VOLUME 46A, SEPTEMBER 2015, pp. 3835–3841 DOI: 10.1007/s11661-015-2965-6
FOLLOWING are corrections to the reference citations in the original article: Page 3835, right column, first paragraph: Plastic deformation in Ti6Al4V material at room temperature was found to be caused by planar slip in the a grains, at quasi-static strain rates, while at high strain rates deformation twinning is also observed.[4] Page 3835, right column, third paragraph: Study conducted by Antonysamy[5] showed favored growth… Page 3835, right column, fourth paragraph: The sentence ‘‘Change in mechanical properties relative to distance from build plate were evaluated in an experiment conducted at NIST’’ should be referenced to the following papers: N. Hrabe and T. Quinn: Mater. Sci. Eng. A, 2013, vol. 573, pp. 264–70. N. Hrabe and T. Quinn: Mater. Sci. Eng. A, 2013, vol. 573, pp. 271–77. Page 3836, left column, first paragraph: Contradictory to the previous studies which showed the preferential… The references cited in this sentence should be changed to: N. Hrabe and T. Quinn: Mater. Sci. Eng. A, 2013, vol. 573, pp. 264–70. N. Hrabe and T. Quinn: Mater. Sci. Eng. A, 2013, vol. 573, pp. 271–77. Page 3836, left column, first paragraph: Opposite to the findings of Ladani et al.[6] which…. Page 3836, left column, second paragraph: Extensive research on EBM technique, quality of parts, types of defects, process parameter effects on defects, microstructure of material produced using this technique and LEILA LADANI, Associate Professor, is with the Mechanical Engineering Department, University of Connecticut, Storrs, CT. Contact e-mail: [email protected] The online version of the original article can be found under doi: 10.1007/s11661-015-2965-6. Article published online March 14, 2016 METALLURGICAL AND MATERIALS TRANSACTIONS A
mechanical behavior of parts over the last decade was conducted by Murr et al.[7–12] Page 3836, left column, second paragraph: The idea that heat extraction can be utilized to form the desired microstructure was explored and to some extent realized by Oak Ridge National Lab recently as a structure was built in a carefully controlled manner in which the grain orientation was dictated and controlled at microscale.[13] Page 3836, second column, first paragraph: Dog-bone specimens are fabricated based on the E8 M-04 ASME standard for subsize specimen using EBM system, Arcam A2 manufactured by Arcam AB in Sweden.[14] Page 3837, left column, first paragraph: these specimens were close to the properties of Ti6Al4V material fabricated using traditional techniques and also comparable to the other tests conducted on EBM postprocessed samples.[15–17] Page 3837, left column, third paragraph: In uniaxial tensile/compressive testing, strain rate sensitivity (SRS) is measured as the change in observed strength as the applied strain rate is varied. SRS is often represented using the f
Data Loading...
