Life Cycle Engineering
The issue of environmental preservation has attracted increasing worldwide attention in the last few decades. This is attributed to factors such as the ever-growing world population and greater affluence. The demand for wealth by the less-developed countr
- PDF / 20,524,292 Bytes
- 831 Pages / 439 x 666 pts Page_size
- 2 Downloads / 155 Views
Springer-V erlag Berlin Heidelberg GmbH
Anatoli Dashchenko (Editor)
Manufacturing Technologies for Machines of the Future 21st Century Technologies
With 431 figures and 41 tables
123
Professor Dr. Sc. ANATOLI 1. DAsHcHENKo Moscow State Technical University MAMI B. Semenovskaya St. 38 lO5839 Moscow
Additional material to this book can be downloaded from http://extras.springer.com ISBN 978-3-642-62822-1 ISBN 978-3-642-55776-7 (eBook) DOI 10.1007/978-3-642-55776-7 Cataloging-in-Publication Data applied for A catalog record for this book is available from the Library of Congress. Bibliographic information published by Die Deutsche Bibliothek Die Deutsche Bibliothek lists this publication in the Deutsche Nationalbibliografie; detailed bibliographic data is available in the Internet at http://dnb.ddb.de This work is subject to copyright. All rights are reserved, whether the whole or part of the material is concerned, specifically the rights of translation, reprinting, reuse of illustrations, recitation, broadcasting, reproduction on microfilm or in other ways, and storage in data banks. Duplication of this publication or parts thereof is permitted only under the provisions of the German Copyright Law of September 9,1965, in its current version, and permission for use must always be obtained from Springer-Verlag. Violations are liable for prosecution under German Copyright Law. © Springer-Verlag Berlin Heidelberg 2003 Originally published by Springer-Verlag Berlin Heidelberg New York in 2003 Softcover of the hardcover 1st edition 2003
http://www.springer.de The use of general descriptive names, registered names, trademarks, etc. in this publication does not imply, even in the absence of a specific statement, that such names are exempt from the relevant protective laws and regulations and therefore free for general use. Product liability: The publisher cannot guarantee the accuracy of any information about dosage and application contained in this book. In every individual case the user must check such information by consulting the relevant literature. Coverdesign: deblik, Berlin Printed on acid-free paper - 5 4 3 2 1 0 62/3020 uw
Editorial Board
1. Prof. W. Pollmann, Head of Editorial Board, Vice-President, DaimlerChrysler AG, Germany 2. Prof. K.V. Frolov, Director of the Mechanical Engineering Research Institute, Russian Academy of Sciences, Russia 3. Prof. Dr. Sc. A.I. Dashchenko, Head of Department, Moscow State Technical University MAMI, Russia 4. Mr. H. Inaba, Senior Vice-President of Fanuc Ltd, Japan 5. Prof. Dr. Eng. M. Santochi, Head of Section, University of Pisa, Italy 6. Prof. Dr. Eng. F. Rehsteiner, ex-Head of the Institute of Machine Tools and Manufacturing, Zurich University, Switzerland 7. Prof. Dr. Eng. habil. J. Peklenik, Head of Department, University of Ljubljana, Slovenia
Workgroup
1. Prof. Dr. Sc. A.I. Dashchenko, Moscow State Technical University MAMI, Russia 2. Mr. W. Samlowski, DaimlerChrysler AG, Germany 3. Prof. Dr. Sc. L.I. Volchkevich, Baumann TU, Russia 4. Prof. Dr. Sc. E.G. Nach
Data Loading...
