Modeling Film Conductivity for Ion Migration Analysis in Perovskite Solar Cells
- PDF / 527,273 Bytes
- 6 Pages / 593.972 x 792 pts Page_size
- 67 Downloads / 169 Views
https://doi.org/10.1007/s11664-020-08232-5 Ó 2020 The Minerals, Metals & Materials Society
PROGRESS AND CHALLENGES WITH PEROVSKITE MATERIALS AND DEVICES
Modeling Film Conductivity for Ion Migration Analysis in Perovskite Solar Cells NIMA E. GORJI,1,2 AMIRHOSEIN MOSAVI,3 ARASH ROUHI,4 PEZHMAN DARVISHZADEH,5 and MAHDI GHADIRI6,7,8 1.—Institute of Research and Development, Duy Tan University, Da Nang 550000, Vietnam. 2.—Faculty of Natural Sciences, Duy Tan University, Da Nang 550000, Vietnam. 3.—Department of Mathematics and Informatics, J. Selye University, Komarno, Slovakia. 4.—Department of New Technologies, University of Tabriz, Tabriz 51566, Iran. 5.—Department of Mechanical Engineering, Shahid Beheshti University, Tehran, Iran. 6.—Informetrics Research Group, Ton Duc Thang University, Ho Chi Minh City, Vietnam. 7.—Faculty of Applied Sciences, Ton Duc Thang University, Ho Chi Minh City, Vietnam. 8.—e-mail: [email protected]
Ion migration under stress is a major degradation challenge for commercialization of perovskite solar cells. This paper presents three different approaches to model the conductivity variation in perovskite films at elevated temperature, prolonged irradiation levels and strain induced in the lattice. The conductivity variation under any of these stressing conditions can represent ion migration across the perovskite layer because the conductivity is related to mobility and carrier densities. Ion migration can elevate the density of electrons/holes across the film if the stress condition reduce/lift the activation energy at the interface of the film and smoothens the ion passivation to the perovskite layer. In addition, the conductivity of the film is related to device metrics (e.g. fill factor) and also to materials properties (e.g. mobility and bandgap) and, therefore, it can be a significant measure of stress impact on device stability. For example, the conductivity falls under stress which represents the ion migration enhancement. In our modeling, we have shown that the conductivity is inversely related to temperature and strain (r µ 1/kT, r µ 1/e) but is directly related to irradiation level (r µ n1/2). We have fitted our modeling to experimental data reported in the literature and extracted the activation energy of ion migration mechanism under every stress condition. The band diagrams of the mechanism are presented and it is shown that stress can foster the ion migration by reducing the activation energy at the interfaces of the perovskite layer. However, the impact of heating is worse on film conductivity, whereas irradiation and strain have a moderate or slight effect on it, respectively. Our findings may provide a practical solution to obtain a measure of ion migration in perovskite solar cells for aging analysis of the cell stability and recovery rates under different stressing conditions. Key words: Thin films, perovskite, conductivity, strain, temperature, ion migration, degradation
INTRODUCTION
(Received March 19, 2020; accepted May 26, 2020)
The power conversion effic
Data Loading...