Optimization of Technological Process by Experimental Design
In the design of technological processes, i.e. in determining of the process parameters, selection of optimal parameters is important factor, regardless of the optimization criterion. If the first order experimental plans are used for finding the response
- PDF / 89,190,555 Bytes
- 871 Pages / 481.889 x 691.671 pts Page_size
- 69 Downloads / 209 Views
Series Editors: The Rectors of CISM Sandor Kaliszky - Budapest Mahir Sayir - Zurich Wilhelm Schneider - Wien The Secretary General of CISM Giovanni Bianchi - Milan Executive Editor Carlo Tasso - Udine
The series presents lecture notes, monographs, edited works and proceedings in the field of Mechanics, Engineering, Computer Science and Applied Mathematics. Purpose of the series is to make known in the international scientific and technical community results obtained in some of the activities organized by CISM, the International Centre for Mechanical Sciences.
INTERNATIONAL CENTRE FOR MECHANICAL SCIENCES COURSES AND LECTURES -No. 372
ADVANCED MANUFACTURING SYSTEMS AND TECHNOLOGY
EDITED BY
E. KULJANIC UNIVERSITY OF UDINE
~
Springer-Verlag Wien GmbH
Le spese di stampa di questo volume sono in parte coperte da contributi del Consiglio Nazionale delle Ricerche.
This volume contains 488 illustrations
This work is subject to copyright. All rights are reserved, whether the whole or part of the material is concerned specifically those of translation, reprinting, re-use of illustrations, broadcasting, reproduction by photocopying machine or similar means, and storage in data banks. © 1996 by Springer-Verlag Wien Originally published by Springer-Verlag Wien New York in 1996
In order to make this volume available as economically and as rapidly as possible the authors' typescripts have been reproduced in their original forms. This method unfortunately has its typographical limitations but it is hoped that they in no way distract the reader.
ISBN 978-3-211-82808-3 DOI 10.1007/978-3-7091-2678-3
ISBN 978-3-7091-2678-3 (eBook)
MATERIALS SCIENCE AND THE SCIENCE OF MANUFACTURING- INCREASING PRODUCTIVITY MAKING PRODUCTS MORE RELIABLE AND LESS EXPENSIVE
ORGANIZERS University of Udine - Faculty of Engineering - Department of Electrical, Managerial and Mechanical Engineering - Italy Centre International des Sciences Mecaniques, CISM - Udine - Italy University of Rijeka - Technical Faculty - Croatia
CONFERENCE VENUE CISM - PALAZZO DEL TORSO Piazza Garibaldi, 18 - UDINE
PREFACE
The International Conference on Advanced Manufacturing Systems and Technology - AMST is held every third year. The First International Conference- AMST'87 was held in Opatija (Croatia) in October 1987. The Second International Conference - AMST'90 was held in Trento (Italy) in June 1990 and the Third International Conference - AMST'93 was held in Udine (Italy) inApril1993.
The Fourth International Conference on Advanced Manufacturing Systems and Technology - AMST'96 aims at presenting trend and an up-todate information on the latest developments - research results and industrial experience in the field of machining of conventional and advanced materials CIM non-conventional machining processes forming and quality assurance thus providing an international forum for a beneficial exchange of ideas, and furthering a favorable cooperation between research and industry.
E. Kuljanic
HONOUR COMMITTEE S. CECOTTI, President of Giunta Regione Autonom
