Machining Difficult-to-Cut Materials Basic Principles and Challenges
This book focus on the challenges faced by cutting materials with superior mechanical and chemical characteristics, such as hardened steels, titanium alloys, super alloys, ceramics and metal matrix composites. Aspects such as costs and appropriate machini
- PDF / 7,200,732 Bytes
- 253 Pages / 453.543 x 683.15 pts Page_size
- 1 Downloads / 175 Views
Hossam A. Kishawy Ali Hosseini
Machining Difficult-to-Cut Materials Basic Principles and Challenges
Materials Forming, Machining and Tribology Series editor J. Paulo Davim, Aveiro, Portugal
More information about this series at http://www.springer.com/series/11181
Hossam A. Kishawy Ali Hosseini •
Machining Difficult-to-Cut Materials Basic Principles and Challenges
123
Hossam A. Kishawy Machining Research Laboratory (MRL) University of Ontario Institute of Technology Oshawa, ON, Canada
Ali Hosseini Machining Research Laboratory (MRL) University of Ontario Institute of Technology Oshawa, ON, Canada
ISSN 2195-0911 ISSN 2195-092X (electronic) Materials Forming, Machining and Tribology ISBN 978-3-319-95965-8 ISBN 978-3-319-95966-5 (eBook) https://doi.org/10.1007/978-3-319-95966-5 Library of Congress Control Number: 2018947784 © Springer International Publishing AG, part of Springer Nature 2019 This work is subject to copyright. All rights are reserved by the Publisher, whether the whole or part of the material is concerned, specifically the rights of translation, reprinting, reuse of illustrations, recitation, broadcasting, reproduction on microfilms or in any other physical way, and transmission or information storage and retrieval, electronic adaptation, computer software, or by similar or dissimilar methodology now known or hereafter developed. The use of general descriptive names, registered names, trademarks, service marks, etc. in this publication does not imply, even in the absence of a specific statement, that such names are exempt from the relevant protective laws and regulations and therefore free for general use. The publisher, the authors and the editors are safe to assume that the advice and information in this book are believed to be true and accurate at the date of publication. Neither the publisher nor the authors or the editors give a warranty, express or implied, with respect to the material contained herein or for any errors or omissions that may have been made. The publisher remains neutral with regard to jurisdictional claims in published maps and institutional affiliations. This Springer imprint is published by the registered company Springer Nature Switzerland AG The registered company address is: Gewerbestrasse 11, 6330 Cham, Switzerland
Preface
Machining or in the other word “material removal” or “cutting” is perhaps one of the oldest manufacturing operations and the most widely used one in almost all industries. The popularity of this process is inherently related to its versatility for use not only as a primary manufacturing operation to obtain different components with variety of shapes but also as a secondary operation after other manufacturing processes. As a secondary operation, the machining process is used to generate high-quality surfaces, which cannot be obtained by other manufacturing processes. Despite the advances in manufacturing technology over the past decades that made it possible to obtain high-quality surfaces using alternative manufacturing techniques, machining op
Data Loading...
