The influence of deviatoric and horizontal differential stress and pore pressure on hydraulic fracture opening by fully
- PDF / 5,121,495 Bytes
- 11 Pages / 595.276 x 790.866 pts Page_size
- 65 Downloads / 154 Views
ORIGINAL PAPER
The influence of deviatoric and horizontal differential stress and pore pressure on hydraulic fracture opening by fully coupled 3D cohesive elements method Seyed Erfan Saberhosseini 1 & Reza Keshavarzi 2 Received: 26 September 2016 / Accepted: 28 December 2018 # Saudi Society for Geosciences 2019
Abstract Estimation of hydraulic fracture opening is one of the most difficult technical challenges in hydraulic fracturing treatment of vertical or horizontal oil wells since proppant transport as well as any possible premature screen out are considerably affected by hydraulic fracture opening (or width). In this study, the influences of deviatoric and horizontal differential stress as well as pore pressure regimes on hydraulic fracture opening in vertical and horizontal oil wells with normal fault regime are investigated. Novel three-dimensional cohesive elements with traction-separation law (XFEM-based cohesive law) are used for simulating the fracture initiation and propagation in a fluid-solid coupling finite element model. The stress intensity factor is verified for both XFEM-based cohesive law and analytical solution to show the validation of cohesive law in fracture modeling, where the compared results are in a very good agreement with less than 1% error. Moreover, the propagation of the hydraulic fracture by cohesive elements approach was also validated by KGD M-vertex solutions with negligible error about 1.6%. The results showed that, generally, by increasing deviatoric and horizontal differential stress, the fracture opening has been strongly affected for both vertical and horizontal oil wells. Additionally, increasing pore pressure from under-pressure regime to over-pressure state of formation pressure has made a considerable rise on fracture opening. Keywords Hydraulic fracturing . Deviatoric stress . Horizontal differential stress . Pore pressure . Cohesive elements . XFEM-based cohesive law
Introduction Deviatoric stress (the difference between minimum and maximum principle stresses) and horizontal differential stress (the difference between minimum and maximum horizontal stresses) as well as pore pressure (which is illustrated by underpressure, normal, and over-pressure states of formation pressure definition) are among the parameters which have significant effects on fracture geometry (Fjaer 2008; Valco and Economides 1997).
* Seyed Erfan Saberhosseini [email protected] 1
Young Researchers and Elite Club, Science and Research Branch, Islamic Azad University, Tehran, Iran
2
Department of Civil and Environmental Engineering, University of Alberta, Edmonton, Alberta, Canada
In situ stresses and pore pressure regimes are very important in success or failure of hydraulic fracturing process in oil and gas reservoirs since they act directly on the fracture geometry such as fracture opening, but knowing those effects before starting any operation in oil and gas fields can be very helpful for designing any fracturing processes; in this way, constructing and analyzing a three-dimen
Data Loading...
