ZnO thin films design: the role of precursor molarity in the spray pyrolysis process
- PDF / 2,356,999 Bytes
- 12 Pages / 595.276 x 790.866 pts Page_size
- 95 Downloads / 178 Views
ZnO thin films design: the role of precursor molarity in the spray pyrolysis process M. P. F. de Godoy1,* W. A. A. Macedo3
, L. K. S. de Herval2, A. A. C. Cotta2, Y. J. Onofre1, and
1
Departamento de FÚsica, Universidade Federal de SÐo Carlos - UFSCar, SÐo Carlos, SP 13565-905, Brazil Departamento de FÚsica, Universidade Federal de Lavras - UFLA, Lavras, MG 37200-900, Brazil 3 Centro de Desenvolvimento de Tecnologia Nuclear, CDTN, Belo Horizonte, MG 31270-901, Brazil 2
Received: 21 May 2020
ABSTRACT
Accepted: 17 August 2020
Many investigations employ oxides grown by spray pyrolysis whose desired features depend on the synthesis parameters. This paper reports the influence of precursor dilution on the structural, morphological, and optical properties of ZnO films. For this purpose, the applied aqueous solutions using zinc acetate as precursor covered a wide range of molarities from 10–3 to 1. The films were deposited on silicon and glass substrates and characterized by several techniques. X-ray diffraction showed that well-diluted conditions are essential for crystalline ordering. Atomic force microscopy and scanning electron microscopy confirmed extensive coating with rougher surfaces on silicon substrates. The optical transparency is remarkable, and the optical emissions measured by photoluminescence are predominantly in the ultraviolet range, related to near band edge transitions. X-ray photoelectron spectroscopy indicated surfaces with a high percentage of adventitious carbon. In contrast, at high molarities, the films are white and powder-like. Defect-level recombination dominates the optical emissions in the visible range. Moreover, the stoichiometric surfaces present lower levels of adventitious carbon. This investigation shows that the precursor molarity is crucial for ZnO films architecture, as demonstrated in their chromaticity characteristics by the redshift of UV emission and the raise of the visible band.
©
Springer Science+Business
Media, LLC, part of Springer Nature 2020
1 Introduction Oxides are fundamental in the current technological and scientific research in materials science and solidstate physics due to their versatility and robustness. They can show metallic, dielectric, as well as
Address correspondence to E-mail: [email protected]
https://doi.org/10.1007/s10854-020-04281-y
superconducting behaviors depending on the constituent elements and the complexity of chemical bonds [1–3]. Even so, binary oxides with semiconductor behavior are suitable for electronics as high power devices and transparent electrodes [4–6]. Therefore, the production of thin films is a strategy to
J Mater Sci: Mater Electron
achieve operability in current silicon technology. One attractive material for these aims is zinc oxide (ZnO). Its physical properties, such as open wurtzite structure, piezoelectricity, and large bandgap (3.4 eV), stand out in several applications as transparent transistors, photodiodes, light-emitting devices among gas sensors, solar cells, and antibacterial activity [7–12]. In the
Data Loading...
