3D printed mask extenders as a supplement to isolation masks to relieve posterior auricular discomfort: an innovative 3D
- PDF / 4,640,277 Bytes
- 5 Pages / 595.276 x 790.866 pts Page_size
- 6 Downloads / 128 Views
TECHNICAL NOTE
Open Access
3D printed mask extenders as a supplement to isolation masks to relieve posterior auricular discomfort: an innovative 3D printing response to the COVID-19 pandemic Zachary O’Connor1, Daniel Huellewig1,2, Peeti Sithiyopasakul3, Jason A. Morris4, Connie Gan4 and David H. Ballard5*
Abstract Purpose: Many commonly used mask designs are secured by elastic straps looping around the posterior auricular region. This constant pressure and friction against the skin may contribute to increased wearer pain, irritation, and discomfort. The purpose of this work is to report a modified 3D printed mask extender to alleviate discomfort and increase mask wearability by relieving posterior auricular pressure from isolation masks. Methods: Our institutional review board designated this project as non-human research and exempt. As part of resourcing 3D printing laboratories along with individual 3D printers to provide resources to healthcare workers, mask extenders were printed to relieve posterior auricular pressure from individuals wearing isolation masks. The authors modifed an existing mask extender, increasing its length with accompanying peripheral rungs for isolation mask securement. 3D printing was performed with Ultimaker S5 (Ultimaker B.V.; Geldermalsen, Netherlands) and CR10 (Creality3D; Shenzhen, China) 3D printers using polylactic acid filaments. The author’s modified extended mask extenders were printed and freely delivered to healthcare workers (physicians, nurses, technologists, and other personnel) at the authors’ institution. Results: The final mask extender design was printed with the two 3D printers with a maximum 7 straps printed simultaneously on each 3D printer. Mean print times ranges from 105 min for the Ultimaker S5 printer and 150 min for the CR-10. Four hundred seventy-five mask extenders were delivered to healthcare workers at the authors’ institution, with the demand far exceeding the available supply. Conclusion: We offer a modification of a 3D printed mask extender design that decreases discomfort and increases the wearability of isolation mask designs with ear loops thought to relieve posterior auricular skin pressure and ability to control strap tension. The design is simple, produced with inexpensive material (polylactic acid), and have been well-received by healthcare providers at our institution.
* Correspondence: [email protected] 5 Mallinckrodt Institute of Radiology, Washington University School of Medicine, 510 S. Kingshighway Blvd, Campus Box 8131, St. Louis, MO 63110, USA Full list of author information is available at the end of the article © The Author(s). 2020 Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in
Data Loading...
