Advances in Corrosion Science and Technology
- PDF / 31,581,806 Bytes
- 352 Pages / 431 x 649 pts Page_size
- 3 Downloads / 234 Views
CORROSION SCIENCE AND TECHNOLOGY VOLUME 2
ADVANCES IN CORROSION SCIENCE AND TECHNOLOGY Editors: M. G. Fontana and R. W. Staehle Corrosion Center, Department of Metallurgical Engineering The Ohio State University, Columbus, Ohio Editorial Board: VITIORIO CARASSITI Universita di Ferrara Ferrara, Italy MORRIS COHEN National Research Council Ottawa, Ontario, Canada JOSEPH E. DRALEY Argonne National Laboratory Argonne, Illinois HELLMUTH FISCHER Technische Hochschule Karlsruhe Karlsruhe, Germany T. P. HOAR University of Cambridge Cambridge, England
JEROME KRUGER National Bureau of Standards Washington, D. C. PAUL LACOMBE L'Ecole National Superieure des Mines de Paris Paris, France MARCEL POURBAIX CEBELCOR Brussels, Belgium SAKAE TAJIMA Tokyo City University Tokyo, Japan
Volume 1 (1970) - Contributors V. CARASSITI DUDLEY DE G. JONES R. M. LATANISION H. G. MASTERSON
S. TAJIMA G. TRABANELLI A. R. C. WESTWOOD
Volume 2 (1972) - Contributors P. C. S. HAYFIELD M. D. HYATI
W. P. IVERSON M. O. SPEIDEL
ADVANCES IN
CORROSION SCIENCE AND TECHNOLOGY VOLUME 2 Edited by Mars G. Fontana and Roger W. Staehle
~PLENU. PRESS· NEWYORI-LONDON· 1912
Library of Congress Catalog Card Number 76-107531 ISBN-13: 978-1-4615-8257-1 001: 10.1007/978-1-4615-8255-7 @
e-ISBN-13: 978-1-4615-8255-7
1972 Plenum Press, New York
Softcover reprint of the hardcover 1st edition 1972
A Division of Plenum Publishing Corporation 227 West 17th Street, New York, N.Y. 10011 United Kingdom edition published by Plenum Press, London A Division of Plenum Publishing Company, Ltd. Davis House (4th Floor), 8 Scrubs Lane, Harlesden, London, NW 10, 6SE, England All rights reserved No part of this publication may be reproduced in any form without written permission from the publisher
PREFACE TO VOLUME 1
This series was organized to provide a forum for review papers in the area of corrosion. The aim of these reviews is to bring certain areas of corrosion science and technology into a sharp focus. The volumes of this series will be published approximately on a yeady basis and will each contain three to five reviews. The articles in each volume will be selected in such a way to be of interest both to the corrosion scientists and the corrosion technologists. There is, in fact, a particular aim in juxtaposing these interests because of the importance of mutual interaction and interdisciplinarity so important in corrosion studies. It is hoped that the corrosion scientists in this way may stay abreast of the activities in corrosion technology and
vice versa. In this series the term "corrosion" will be used in its very broadest sense. This will include, therefore, not only the degradation of metals in aqueous environment but also what is commonly referred to as "hightemperature oxidation." Further, the plan is to be even more general than these topics; the series will include all solids and all environments. Today, engineering solids include not only metals but glasses, ionic solids, polymeric solids, and composites of these. Environments of interest must be extend
