Carbonate mineral identification and quantification in sediment matrices using diffuse reflectance infrared Fourier tran
- PDF / 681,585 Bytes
- 6 Pages / 595.276 x 790.866 pts Page_size
- 83 Downloads / 214 Views
ORIGINAL PAPER
Carbonate mineral identification and quantification in sediment matrices using diffuse reflectance infrared Fourier transform spectroscopy Rachel T. So1 · Neal E. Blair1,2 · Andrew L. Masterson1 Received: 30 April 2020 / Accepted: 1 June 2020 © The Author(s) 2020
Abstract Carbonate minerals are a major reservoir in the global carbon cycle and a key player in the sequestration and emission of atmospheric CO2. In addition to the minerals’ frequent use in agriculture and construction, carbonate formation has been targeted for anthropogenic CO2 sequestration. Due to carbonate’s importance in geological and anthropogenic realms, research on carbonate characterization and quantification is of interest. Here, we demonstrate a method to identify and quantify calcite (CaCO3) and dolomite (CaMg(CO3)2) in sediment matrices using diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS). Needing only a few minutes per sample, DRIFTS is a rapid technique that does not require hazardous chemicals and does not destroy samples during analysis. We selected the 2515 ± 9 cm−1 absorbance bands for quantification as they exhibited little interference from sediment matrix minerals and large peak areas relative to other bands. The DRIFTS technique was compared to the traditional acidification headspace analysis method on artificial mixtures of sediment and carbonate as well as natural lake bed and river bank samples from the Upper Sangamon River Basin in Illinois, USA. DRIFTS offers an additional advantage over acidification in that it permits carbonate mineral identification simultaneously with its quantification. Though DRIFTS estimates were higher, a good correlation was found between DRIFTS and acidification estimates for both lake sediments (R2 = 0.99) and bank samples (R2 = 0.92), indicating DRIFTS is a reliable method for carbonate quantification in sediment matrices. Keywords Carbonate quantification · Calcite · Dolomite · DRIFTS · FTIR · Sediments
Introduction At 60 million Pg C, carbonate rocks are the largest carbon reservoir in Earth’s lithosphere (Sharp 2007). It has a key role in long-term climate regulation as carbonate dissolution/precipitation leads to the sequestration/emission of the greenhouse gas CO2 (Berner et al. 1983). Mirroring the natural system, prominent anthropogenic carbon sequestration approaches rely on carbonate formation (Oelkers et al. 2008; Wang et al. 2020). Two of the most abundant carbonate minerals are calcite (CaCO3) and dolomite (MgCa(CO3)2), * Neal E. Blair n‑[email protected] 1
Department of Earth and Planetary Sciences, Northwestern University, Evanston, IL 60208, USA
Department of Civil and Environmental Engineering, Northwestern University, Evanston, IL 60208, USA
2
both commonly used by humans in agriculture, construction, and carbon sequestration schemes (Biasi et al. 2008; Legodi et al. 2001; Oelkers et al. 2008; Sun et al. 2014; Wang et al. 2020). Due to its prominence in the carbon cycle and in anthropogenic activities, carbonate miner
Data Loading...
