Correction to: The influence of stiffener geometry on flexural properties of 3D-printed polylactic acid (PLA) beams
- PDF / 338,840 Bytes
- 1 Pages / 595.276 x 790.866 pts Page_size
- 92 Downloads / 242 Views
CORRECTION
Correction to: The influence of stiffener geometry on flexural properties of 3D‑printed polylactic acid (PLA) beams Silas Z. Gebrehiwot1 · Leonardo Espinosa‑Leal2 · J. N. Eickhof3 · L. Rechenberg3
© The Author(s) 2020
Correction to: Progress in Additive Manufacturing https://doi.org/10.1007/s40964-020-00146-2
The publication of this article unfortunately contained a mistake. The name of the second author was wrong, correct it should be L. Expinosa Leal instead of E.L. Leonardo. The original article has been corrected.
The original article can be found online at https://doi.org/10.1007/ s40964-020-00146-2. * Silas Z. Gebrehiwot [email protected] 1
Material and Energy Engineering, Arcada University of Applied Sciences, Helsinki, Finland
2
Business Management and Analytics, Arcada University of Applied Sciences, Helsinki, Finland
3
Mechanical Engineering, Frankfurt University of Applied Sciences, Frankfurt, Germany
13
Vol.:(0123456789)
Data Loading...
