Erratum to: Microstructure design for fast oxygen conduction
- PDF / 27,461 Bytes
- 1 Pages / 584.957 x 782.986 pts Page_size
- 10 Downloads / 176 Views
doi: 10.1557/jmr.2015.327, Published by Materials Research Society with Cambridge University Press, 11 November 2015.
Processing of Al–12Si–TNM composites by selective laser melting and evaluation of compressive and wear properties – ERRATUM Konda G. Prashanth, Sergio Scudino, Anil K. Chaubey, Lukas Löber, Pei Wang, Hooyar Attar, Frank P. Schimansky, Florian Pyczak, and Jürgen Eckert.
doi: 10.1557/jmr.2015.326, Published by Materials Research Society with Cambridge University Press, 12 November 2015. In Aidhy,1 there should have been a footnote for co-author William Weber as follows:
and publication of manuscripts authored by editors, please refer to http://www.mrs.org/jmr-editor-manuscripts/.
This author was an editor of this journal during the review and decision stage. For the JMR policy on review and publication of manuscripts authored by editors, please refer to http://www.mrs.org/jmr-editor-manuscripts/.
The editors regret these attribution errors, and the originals have since been corrected.
In Prashanth,2 there should have been a footnote for co-author Jürgen Eckert as follows: This author was an editor of this journal during the review and decision stage. For the JMR policy on review
REFERENCES 1. D.A. Aidhy and J.W. Weber. Microstructure design for fast oxygen conduction. J. Mater. Res. 31(1), 2–16 (2016). 2. K.G. Prashanth, S. Scudino, A.K. Chaubey, L. Löber, P. Wang, H. Attar, F.P. Schimansky, F. Pyczak, and J. Eckert. Processing of Al–12Si–TNM composites by selective laser melting and evaluation of compressive and wear properties. J. Mater. Res. 31(1), 55–65 (2016).
DOI: 10.1557/jmr.2016.15 J. Mater. Res., Vol. 31, No. 1, Jan 14, 2016
Ó Materials Research Society 2016
173
Data Loading...
