High Speed Cutting
- PDF / 1,818,195 Bytes
- 24 Pages / 504.567 x 720 pts Page_size
- 30 Downloads / 249 Views
High Speed Cutting Rafael Wertheim Fraunhofer Institute for Machine Tools and Forming Technology IWU, Chemnitz, Germany
Synonyms HPC – High Performance Cutting; HSC – High Speed Cutting; HSM – High Speed Machining
CIRP’s main activities within High Speed Machining (HSM), or High Speed Cutting (HPC) and High Performance Cutting (HPC) topics within the STC “C,” are shown in Fig. 1. During the 61st General Assembly, 2011, in Budapest, a keynote paper on velocity in forming and cutting was presented and discussed including HSM and HPC (Neugebauer et al. 2011).
Theory and Application High Speed Cutting: Fundamentals
Definition
Introduction
The main challenges in metal cutting today lie in the development and application of innovative strategies aimed, firstly, at reducing cycle time and costs for better productivity and higher profitability, and also for improved performance and especially at reducing the amount of energy and resources used as well as emissions. In machining, for example, lightweight materials or high temperature alloys, the use of high machining conditions (HSM & HPC) is often restricted by the machine’s capacity or in terms of tool wear and workpiece machinability. In general, the use of high velocity may lead to reductions in cutting forces, power, and energy, something which will in turn have a positive effect on tool and machine design.
CIRP’s main activities within High Speed Machining (HSM), or High Speed Cutting (HPC) and High Performance Cutting (HPC) topics within the STC “C,” are shown in Fig. 1 (See “Definition”). During the 61st General Assembly, 2011, in Budapest, a keynote paper on velocity in forming and cutting was presented and discussed including HSM and HPC (Neugebauer et al. 2011). In the mid-1980s, Prof. Schulz initiated the HSM (or HSC) activities which are going on even today. Many CIRP meetings and conferences took place and a large number of scientific and technological papers were presented. During the 1990s, additional and new highlights such as dry cutting or MQL as well as hard cutting (HC) were emphasized.
# CIRP 2018 The International Academy for Production Engineering et al. (eds.), CIRP Encyclopedia of Production Engineering, https://doi.org/10.1007/978-3-642-35950-7_6407-4
2
High Speed Cutting
1985 − 2002 Scientific basic research on High speed Machining (HSM or HSC) with n > 40.000 min-1 1991 − 1998 Joint project “Dry machining of prismatic parts” started by BMBF* in Germany 1995 → Today Hard Cutting (HC) to replace Grinding
Basic reasearch and performance
Joint CIRP projects and conferences on HSM and HPC
Machine Tools for n> 40.000 min-1(HSM) 2002 → Today and using existing HPC with high loads machining centres n< 8.00 min-1 and high removal rates
HSS
1907
Technology Developments Cutting Tools and Materials
1990
1995
2000
Demand for reduced cutting time, cost, energy and resources
2010 2010: HPC Conf. Nagaragawa - Japan
en
ce
s
2008: HPC Conf. Dublin - Ireland 2006: HPC Conf. Vancouver - Canada
RP
Co
nf
er
2004: HPC Conf. Aachen - German
Data Loading...
