• PDF / 4,362,038 Bytes
• 13 Pages / 612 x 792 pts (letter) Page_size
• 34 Downloads / 221 Views

DOWNLOAD

REPORT

Powder Metallurgy T15 Tool Steel: Part II. Microstructure and Properties after Heat Treatment K.S. KUMAR, A. LAWLEY, and M.J. KOCZAK The effect of powder particle size and heat treatment on the microstructure and properties of hot isostatically pressed ("hipped") T15 tool steel has been evaluated. Gas-atomized powder was screened into size fractions covering the range of -

Recommend Documents

Microstructure and Tribological Properties of Tool Steel AISI O2 After Thorough Cryogenic Heat Treatment

215 3 3MB

Heat-Treatment Effects on the Microstructure and Tensile Properties of Powder Metallurgy Ti-6Al-4V Alloys Modified with

212 86 2MB

Machinability of Green Powder Metallurgy Components: Part II. Sintered Properties of Components Machined in Green State

168 77 483KB

Effect of Heat Treatment on Microstructure and Mechanical Properties of Ti-6Al-4V-1.5Mn Fabricated by Powder Metallurgy

240 94 3MB

Heat treatment of investment cast PH 13-8 Mo stainless steel: Part I. Mechanical properties and microstructure

169 8 3MB

Heat Treatment of Thixo-Formed Hypereutectic X210CrW12 Tool Steel

191 59 1MB

Tool Steel Heat Treatment Optimization Using Neural Network Modeling

174 23 5MB

Heat Treatment Optimization and Properties Correlation for H11-Type Hot-Work Tool Steel

176 26 2MB

The effect of heat treatment on microstructure and cryogenic fracture properties in 5Ni and 9Ni steel

223 26 3MB

Effects of Heat Treatment Parameters on the Microstructure and Properties of Bainitic Steel

188 89 3MB

Effect of Cooling Rate on Microstructure and Mechanical Properties of Eutectoid Steel Under Cyclic Heat Treatment

253 115 4MB

Microstructure and properties evolution of Nb-bearing medium Cr wear-resistant cast steel during heat treatment

191 88 4MB