Failure Investigation of a Blast Furnace Top Gas Recovery Turbine: Chronology and Mechanism
- PDF / 5,408,033 Bytes
- 12 Pages / 595.276 x 790.866 pts Page_size
- 87 Downloads / 194 Views
TECHNICAL ARTICLE—PEER-REVIEWED
Failure Investigation of a Blast Furnace Top Gas Recovery Turbine: Chronology and Mechanism . Susovan Das . Himangshu Mandal . Omji Anand . Kaushal Kishore Goutam Mukhopadhyay . Manashi Adhikary . Anup Kumar
Submitted: 15 June 2020 ASM International 2020
Abstract Top gas recovery turbine (TRT) is used to utilize high top pressure for power generation in modern blast furnaces. A failure occurred in the TRT system that led to interruption in operation and reduced power generation. A large increase in vibration of turbine dischargeside bearing was reported prior to the failure. Failure investigation consisted of collection and analysis of plant data, on-site and visual observations, chemical analysis, microstructural analysis using optical and scanning electron microscope coupled with energy-dispersive spectroscopy and hardness measurements. Both the failed components, that is the connecting piece and the rotor blade, were composed of AISI 420 martensitic stainless steel. In the failed connecting piece, fatigue fracture characterized by ratchet and beach marks were identified to occur from a step, a potential stress concentration site. Analytical scanning electron microscopy revealed that the fatigue cracks originated from the corrosion pits having iron oxide scale rich in sulfur and chlorine. Pitting occurred due to breakage of passive chromium oxide film due to acidic water in the system containing high concentration of chlorine. Crack propagation occurred predominantly along the chromium carbide/tempered martensitic interface.
K. Kishore (&) G. Mukhopadhyay M. Adhikary A. Kumar R&D and Scientific Services, Tata Steel Limited, Jamshedpur, India e-mail: [email protected]; [email protected] S. Das H. Mandal Shared Services Technology Group, Tata Steel Limited, Jamshedpur, India O. Anand Mechanical Maintenance, Tata Steel Limited, Jamshedpur, India
Stator blades failed subsequently in brittle mode. Lower hardness of the connecting pieces compared to the stator blade would have promoted fatigue failure in the former component. Based on the analysis, primary mode of failure is termed as ‘‘corrosion fatigue.’’ Practical recommendations are provided to improve the reliability of the system. Keywords Top recovery gas turbine Corrosion fatigue Chloride Pitting Martensitic stainless steel
Introduction Iron and steel industries are among the most energy-intensive sectors and are under constant pressure to reduce carbon footprint [1]. As such, serious attempts have been made in last few decades to standardize the practices of waste recovery and reuse. Top gas energy recovery turbine (TRT) is an efficient and established technology to recover the residual heat and energy of blast furnace gases after cleaning [2–4]. Blast furnace gases are commonly termed as ‘‘top gas,’’ and therefore this technology to recover their energy using turbine is called ‘‘top gas energy recovery turbine (TRT).’’ It is believed that the output of TRT can meet up to 30% of the
Data Loading...
